Total name£ºStripping
Model£ºcommon
Operation number£º5
Process content£ºcrimping
Version: A/1
issue date: 20180225
Revision date: 20180305
Made:
Checked:
Certified:
Input parts: Part No/specification:
Quantity :
Pull inspection:
As the picture shows :
1.First set the terminal
2.Cut off the insulation crimp of the terminal.
Locked on terminal in rally meter card position
Lock the wire
in rally meter line clip
Operation method:
1.As shown in Figure 1; operating at the specified length as shown in the figure, in one cycle, the pressing can not be loose.
2.As shown in Figure 2: The crimped terminal is tested with a puller, Comparison
process parameter table
3. Visual inspect the crimp terminal for obvious defects such as:
a. The wire is loose and not completely
rivet pressed.
b. Terminal deformation damage.
c.The strands extend beyond the terminals.
c The strands extend beyond the terminals.
Inspection standards:
According to the drawings, first middle and last piece inspection
Confirm method:
Visual inspection and meter
Confirm frequency: 10%
Operation tool: Puller
Process parameter:
Conductor nominal cross sectional area mm2 £º Rally value N£º
0.3-0.5 50
0.75-0.85 80
1.0-1.25 100
1.5-2.0 150
2.5-3.0 200
When ¢Ù or more terminals are connected to two or more wires at the same time, select the wire with the largest cross-section to measure the tension.
Previous£º The output of the encoder circuit mode
Next£º Motor with encoder zero phase compensation method and device¢ò
